Hi friends!
I am trying to found a solution for PJ-324 (and PJ-307), 5 pins connectors.
https://www.docdroid.net/DWm7pMe/pj-324m-35mm-stereo-pcb-socket.pdf
https://www.docdroid.net/VTVw1RN/jw-pj-307-5-35mm-stereo-pcb-socket.pdf
If you check the datasheet then you can see that the pin aren't circular.
I made a pad using the polygon. But now I have two problems: the first is that I am seen as a Wire so I can not associate a number to the pad, the second is that I have to move it as if it were a group otherwise change its size.
I have had to do so for get a pad with a long, narrow hole, not circular.
I have not simply superimposed two areas of copper on sides 1 and 16 followed by holes for two reasons: I need the hole to be metallized, the hole should not be uneven.
Please, how can I make a pad of this type?
Thank you in advance!
Added 6 years, 5 months ago.
Hi there! Are you using Eagle or another design tool?
Answered 6 years, 5 months ago.
Hi SnapEDA Admin!
I'm using Eagle but I have not a big experience with it.
Answered 6 years, 5 months ago.
Hello Augusto!
Thank you so much for your reply! To create non-circular pads I'd recommend you to follow this tutorial that shows the official way to create these parts. https://www.autodesk.com/products/eagle/blog/what-you-didnt-know-about-eagle-slotted-holes/
Hope that helps and please let us know if you need anything else.
Answered 6 years, 5 months ago.
Hi SnapEDA Admin!
These informations are the right answer to my question.
Thank you very much.
Kind regards.
Answered 6 years, 5 months ago.
Answered 6 years, 5 months ago.